PARTS WANTED...Please Post

[DansBlown73Nordic]

I thought since we have a For Sale section why not a WANTED....
I need a BBC tunnel ram oval or square port.
Also looking for a Timing cover that is chrome or aluminum with the water pump drive.
A good used shaft coupler 1 i.n.

[CircleJerk]

You trouble maker! Obsurd, no one would want to post here!
Wanted: Nicson or other aluminum timing cover for a BBC, will pay any reasonable price. Also could use a set of 12% gears 12degree.

[boatguy222]

Dan,
I still have this cav plate set up for the Schiada, Are you interested in that?
[ March 02, 2003, 09:38 AM: Message edited by: boatguy222 ]

[Cheyenne 572]

I have two tunnelram's for sale both are rectangle port and they fit BBC.Which one do you want?Oh yes they are polished also.One is for Dominator's and the other will take 4150's carb's.
Later
Jim S

[Fiat48]

I need a dry sump pan for a Big Block Chevy. Also need some 12 degree 35% Gears (I know they are rare). Also need a square type water pickup that goes on the cavitation plate. Could also use a Diest Blower restraint (certifiable) for a 6/71.

[DansBlown73Nordic]

BoatGuy222 I thought you had sold the plate parts. As of now Im knee deep in this Nordic project.

[GofastRacer]

Ok, I'm looking for a needle in a hay stack here!. Anybody know where I can get a set of these stacks?(seems like nobody makes them anymore), actually, just the tops would be even better, that way I can make em the lengh I want!..Thanks...
[img]http://www.***boat.net/image_center/data/500/12Image009.jpg[/img]

[stump]

www.hilborninjection.com
[ March 02, 2003, 02:59 PM: Message edited by: stump ]

[FlatRat]

Looking for a L.H.1" bore 12"x15" or 11 1/2"x15" two blade prop.Thanks.

[RCM]

Dan, I have a tunnel ram for bbc that is rect. port that I don`t need and its only got less than an hour running time on it. RCM