Reply With QuoteYou looking to sub out any work? Or do work on contract kinda deal.
I'd be interested in doing the parts, but I'd rather do them in my shop, then drive up there to do them.
RD
We're looking for a manual machinist to run conventional mills / lathes, some CNC and Waterjet experience would be helpful. Full time or contract, mainly automotive concept and prototype parts. Must be highy experienced.
PM me with contact info if you are interested.
You looking to sub out any work? Or do work on contract kinda deal.
I'd be interested in doing the parts, but I'd rather do them in my shop, then drive up there to do them.
RD
I'll under cut RD lol
Hey RD, I've been to their place before. Didn't get past the lobby and it was impressive. It would be worth the drive just to work with those guys.
Hey RD, I've been to their place before. Didn't get past the lobby and it was impressive. It would be worth the drive just to work with those guys.
Agreed 100%. I got a shop tour.
You should see our roll up doors
I got your e-mail this morning Dan-O, good luck on the new job. Hopefully your new boss isn't too much of a pain in the azz.
You should see our roll up doors
I got your e-mail this morning Dan-O, good luck on the new job. Hopefully your new boss isn't too much of a pain in the azz
Couldn't be worse than my current one.
Hey RD, I've been to their place before. Didn't get past the lobby and it was impressive. It would be worth the drive just to work with those guys.
Might have to go check it out sometime.. I love shit like that.
I've been to some pretty impressive facilities over the years, One of the coolest places I used to go was swift engineering. I used to go down there almost weekly to drop off parts, and check out their wind tunnel testing etc..
RD
Thought saw an ad for Catia designers there as well.
I'll line up for the sub as well.
I do all types of proprietary work.
Brian
Posting Permissions