Pretty sure the 830 holley on my daughters v-drive needs some work.
is there a reputable shop in orange county for rebuilds? Thanks
v-drive
daughers v drive - I just fell in love lol
Pretty sure the 830 holley on my daughters v-drive needs some work.
is there a reputable shop in orange county for rebuilds? Thanks
v-drive
Pretty sure the 830 holley on my daughters v-drive needs some work.
is there a reputable shop in orange county for rebuilds? Thanks
v-drive
daughers v drive - I just fell in love lol
Sean Murphy Induction - Huntington Beach
http://www.smicarburetor.com/
-Justin
C+J Performance in Whitter
(562) 946-1388
Just had two 660s done, tell them what type of motor, what kind of cam you're running, and they'll set your carb up to it. All I had to do was set the idle, great work.
C+J Performance in Whitter
(562) 946-1388
Just had two 660s done, tell them what type of motor, what kind of cam you're running, and they'll set your carb up to it. All I had to do was set the idle, great work.
What did they charge you? I need to get my domis all done up and ready for my engine. I hear they do great work.
The Carb Shop in Ont.
What did they charge you? I need to get my domis all done up and ready for my engine. I hear they do great work.
I had two 660's recently done at The Carb Shop and the chagre was 200 each. They look like new and work great. Set the idle and go.
C+J Performance in Whitter
(562) 946-1388
Just had two 660s done, tell them what type of motor, what kind of cam you're running, and they'll set your carb up to it. All I had to do was set the idle, great work.
Copy that. John knows his chit over there. I've had him do all of my carbs over the years and have always been far from disappointed.
Bigs Performance ( http://www.bigsperformance.com )
They are not local but i shipped my carbs to them and they did a awsome job, My carbs had fuel sitting in them and sat outside for about 10 years, before that they where run for probably another 5+ years with out a rebuild. They where in terrible shape. BIGs cleaned them up, painted them the color i wanted, and they even set the carbs up for my application. I gave them all my motor specs and when i finally got my motor together and fired it up a few weeks ago (check the teaser thread in gear heads) it ran perfect, all i had to adjust on the carb was the idle.
Thanks everyone, if we can't iron this out we now know where to go
v-drive