cams

[tx-19]

thinking of changing my cam and just wondering who the best manufacture would be to go with.any inforamation would appericated thanks

[ck7684]

Bullet (Ultradyne), Crower...

[Sleeper CP]

Roller. Flat tappet or what? Ford, Chevy, Mopar? What?
Comp,Isky,Crane,Crower.
Sleeper CP

[RCB19]

LSM Engineering.

[supersoaker509]

Bullet or cstroub69 here on HB
both are excellent and know there sh****t

[hotbo]

well ill tell ya what i think:idea: which isnt much.i have always been very impressed with comp cams products.but i have come to find in the end if you will spend the time and extra money to get a personal cam ground fro your app.it will pay off in the end ive been talking to chris straub and like what he has to say.ive always felt i can research enough to find a good cam to perform like its suppose to.:idea:the best thing i can tell you is to talk to alot of peeps and find a happy meduim there is so many opinons you will get lost on hearsay.:jawdrop: just to tell ya a few ive had good luck with mind you this is for bbc.stock compression with intake and carb change comps 282 solid 236-561,110,106.9.5 up294s-248-595, 110-106 or comp grind number 604-5,256-266,580,605. 108-108 i have run these cams and been very impressed.call straub technologies he will make all the power you can make with just a cam change alone it will be worth it.i never delt with bullet cams but heard great things about them.

[tx-19]

its for a big block stroker deal. does chris straub do all his cams in house?i have heard nothing but good things about this guy and wanted to get some feed back on people who has used his cams.

[Nucking futs]

Chris struab did my cam as well as my brothers. Mine is not complete, but my brothers little 496 10.2:1 made 710 hp. Mine should be in the low 800's with the same compression just more inches.

[hotbo]

its for a big block stroker deal. does chris straub do all his cams in house?i have heard nothing but good things about this guy and wanted to get some feed back on people who has used his cams.
from what i hear yes.he is a super nice guy and takes the extra time to talk with you.
i had comp custom grind me a cam based on me and the techs specs. aluminium heads and the ole 496 package.it is my ole mans motor that i just built.10.2 and the normal goodies.it makes 717hp at 6000rpm and he turns 6200.the specs on his cam is .050 254-260,661,668,108ls,i installed it at 106 centerline so far he has been pleased with it.

[shaun]

Talk to Chris Straub, he designs the cam and bullet cranks them out! I just got mine together and could not be happier. It doesn't matter what rpm i'm at the power is there and when i decide to stand on it, it goes! Not only that but throttle response is lightning fast!