Reply With Quote
Can anyone give me some tips on how to port the stator / bowl to increase flow?
Your going to get very mixed opinions, on this topic. The just of it is to sharpen the front of the vanes, blend the casting on the front side,as deep as you can go. Then on the back side, the exit of the vanes are shaped like the trailing edge of an airplane wing, to help straighten the water flow at the end of the vanes. The Pro's do beautiful work on this,there for I leave it to them, but there are do it your selfer's out there that prefer to do there own mod's which is fine. Performance could be compromised if your not careful. Hold tight, for more info :rollside:
Sleek
