Reply With QuoteYou got some pretty good advice over on the other site...:idea:
ok guys here is what happened, running the boat yesterday and all was fine. making one more pass about 3/4 throttle about 5500. when it felt like it dropped one cylinder and was only running on 7, right after the loss of power on the left bank (drivers side) I heard a tick, tick, tick sound not very loud just there and it as running bad. shut it down and put it on the trailer, my pops told me to pull the valve cover and look for a loose roller rocker or something along those lines, did not find anything. Checked all the springs and inner springs seem to be ok, only thing I did notice is that the roller for #1 cylinder adjuster is adjusted different than all the others (see picture below)
http://i195.photobucket.com/albums/z...n/IMGP2446.jpg
http://i195.photobucket.com/albums/z...n/IMGP2445.jpg
http://i195.photobucket.com/albums/z...n/IMGP2442.jpg
any help on this is appreciated.. checked the roller to make sure it was on the right way, ok. going to do a comp check and go from there... what do you guys think, any input is helpful!!
You got some pretty good advice over on the other site...:idea:
yeah for sure just getting all the info I can you understand.
never too much knowledge when you own one of these boats!!
More info is needed. What kind of cam? hydraulic, solid, roller, hyd roller... Maybe a dead lifter, stuck or bent valve.
If that rubber line is your fuel line,, that straw might not be enough and starved it to the point of being lean.
Dont know without more info
good luck to ya
You got some pretty good advice over on the other site...:idea:
What other site? there MUST be one that is better then this that I dont know about
What other site? there MUST be one that is better then this that I dont know about
Hmmm thought you also posted your question over on www.performance boats.com
sorry bout that.
Take your oilfilter apart and look for metal particles and that could tell you what happened.
If you have particles in your filter and they are of the steel type the you probably lost a lube on the cam.
Hmmm thought you also posted your question over on www.performance boats.com
sorry bout that.
I was hoping someone would tell me there is a better site then this one. This place isnt what it used to be
Posting Permissions