I changed my water cooling layout due to the addition of a rex thermostat. My cooling layout is like the picture below.
My t valve takes a while to close all the way now. I think its because the t valve and the t for the engine inlet are close together. Has anyone ever tried to make the spring stiffer. I found that 1/4 inch flat washer fit perfect in the bottom of the t valve and would compress the spring a bit to make it stiffer. Has anyone ever tried this? The picture below is my setup. The water comes in off the pump from the left side of the picture. The rest is self explanitory.
[ February 25, 2003, 12:44 PM: Message edited by: Taylorman ]