Did you get a scoop? Dam...I forgot all about getting measurements for you!!! Mine does not have any holes other than for the carbs.
I'm building a scoop tray. Does anybody know if I should make a hole to let out some air? I thought I remembered reading that on here somewhere.
Did you get a scoop? Dam...I forgot all about getting measurements for you!!! Mine does not have any holes other than for the carbs.
Yeah, it's an unlimited products sc-150. It looks like yours. No worries about the numbers. Are you running any kind of air filter? I'm having trouble finding one that will fit, and a plug too.
I run two flame arrestors, that's all. My plug/cover was custom made by an upholstry shop. Works ok, I haven't seen a true foam plug like the ones Harwood uses for aero scoops etc...
My arrestors are only about 2" tall FYI.....good luck!
This is the tray I made for mine. I made it so I could fit a 9x5 inch K&N in it. I didn't put any holes in it, but it has crossed my mind to do. http://www.***boat.com/image_center/...937picsj23.jpg