Can a prop give bow lift???

[gnarley]

Ian, Whats the pitch on that screw? Has it been worked on at all? Any cupping? What's the drive ratio?

[RiverToysJas]

Ian:
...With two people and about twenty gallons of gas it runs 60MPH at about 4800 rpm's, ...Is that GPS speed?

[Ian]

Yes it is GPS, I'm not sure what gears are in the outdrive and I don't belieive the prop has ever been to the shop

[Well Done]

Ian,
You have a nice looking boat. I know a few fellow boaters who would like to have one like yours.

[Ian]

Well you know what they say, everythings for sale. wink I wouldn't mind getting into an older Daytona.

[Kim Hanson]

Infomaniac:
Kim you need to raise that engine about 6 inches. Maybe more My jackplate does that Info,I can raise it alot .......( . )( . ).....

[Havasu Hangin']

Kim Hanson:
My jackplate does that Info,I can raise it alot .......( . )( . )..... I'm gonna go out on a limb and say that you'll pick up at least 3MPH without that tie-down wrapped around the lower case, too...

[Kim Hanson]

Your funny HH,I was setting the timing on it and didn't need to take off the hold down strap.Notice the nice plug's,all 3 where left at home and the best I could come up with was my T-shirt.lmao....( . )( . )..... [img]http://free.***boat.net/ubb/Avatars/Forum_Graphic_Depot/30-pitch.JPG[/img]
[ January 17, 2003, 07:36 PM: Message edited by: Kim Hanson ]

[mike37]

steve@kps
Id like to know what prop works best on your HTM
like to know the best one for my boat
how is it going are you close to finishing it

[Havasu Hangin']

Kim Hanson:
Notice the nice plug's,all 3 where left at home and the best I could come up with was my T-shirt...Whew...you were scaring me for a minute, there Kim...
I was gonna tell ya that it's probably not a good idea to run around with paper towels for plugs!
Glad you got it under control...