Very,Very nice! looks like you did your homework on the mill. Should run hard for a long time. Dig the paint work too.
congrats.
fog
P.S. a couple of nitrous plates would sure be groovy under those carbs!
Yeah, that's pretty. Looks like you did ceramic coating on the headers and intake? Looking forward to seeing some closeups of the motor n such.
Very,Very nice! looks like you did your homework on the mill. Should run hard for a long time. Dig the paint work too.
congrats.
fog
P.S. a couple of nitrous plates would sure be groovy under those carbs!
very nice job!! looks very clean
Ok today I took some pictures of the interior as well as more pictures of the motor. click on this link to see them. http://www.***boat.com/image_center/...=665&password=
Dude, i can't say enough about how nice that boat is. Two words
Awe Some.
Hack job, if your out there, post some pictures of your interior. I like the look of the bucket seats in the rear.
"S 4X4,
I am a V-Drive Guy, but I want to tell you that you have done a Beautiful Job
on your "project". Enjoy it this summer!!
Very nice ! good job .
thanks guys its a great feeling to get compliments on a job done from the heart.
Sniper4x4
Your boat looks sweet!
I see you have installed your banderlog water injection valve on the side of one of your stringers. I was just wondering if you had any problems with it getting wet and if this has caused any problems for you? I am asking because I want to install mine in the same place and the manual says to install it in a dry place.
That thing look's Bitchen!!!!!! You did a great job!!!!!
Later BK