I just went down and measured my setup. 8-71 blower on a Hampton comp. manifold with a MSD dist. and I have 1 3/8" clearance to the nearest ign wire coming out of the cap. The 10-71 is one inch longer so you would still have 3/8" clearance.
Hello everyone
Will a standard MSD small dia. dist. fit on a BDS comp mamnifold with a 1071?
[This message has been edited by Customlinkage (edited March 25, 2002).]
I just went down and measured my setup. 8-71 blower on a Hampton comp. manifold with a MSD dist. and I have 1 3/8" clearance to the nearest ign wire coming out of the cap. The 10-71 is one inch longer so you would still have 3/8" clearance.
Thanks Unchained
It works with my 1071 Mooneyham blower and manifold.
Willis,
Are you going to run your boat at the next NJBA races?
Brent
Originally posted by SPECTRABRENT:
Willis,
Are you going to run your boat at the next NJBA races?
Brent
I have completed my engine, started it today and set the timing, need some odds n ends. I'm going to try. Need a 2x Lifeline vest.
Originally posted by Unchained:
I just went down and measured my setup. 8-71 blower on a Hampton comp. manifold with a MSD dist. and I have 1 3/8" clearance to the nearest ign wire coming out of the cap. The 10-71 is one inch longer so you would still have 3/8" clearance.
Unchained,
Thanks for the info, i just started my setup and I have 1.25" of clearance. I'm using a Mooneyham 1071 and BDS comp. Thanks for the info. The engine ran fine!