check your pm
Anyone know of a good version of desktop dyno. I would like to get a copy.
Thanks
Ok, who uses Dyno2000?
I have a question. Im putting in info that calculates compression ratio. It asks for distance the piston is down from tdc within range .100-2.00 inches. They also ask for volume above piston from .10-6000 cc. Im not to clear on what they are asking for. It seems like it wouild need the distance the piston is in the hole for the # 4 but the value range it accepts .100-2.0". I know pistons are not .100 below the deck. Also i assume for #5 volume above piston, i assume they are asking for the cc's measurement for the dish in the top of the piston but it asks for the piston to block deck volume here in cc's from .10-6000cc's. WTF.
Originally posted by Taylorman
Ok, WTF.
I DUNNO I couldn't even get the link to work!
Me compumoron!
Peace Man!
CESAR