just check the ups tracking that diverter will be in your door today
so last night we were finishing up the body work on the bottom of my hull and all that was left was the holes in the transom for the old exhaust. I had some 1-inch thick MDF to fill the holes with and nothing to cut it with. Couldnt find the hole saws or jigsaw. So i got resourceful and hammered a couple of 4-inch roundx1-inch thick body lift bushings out of a Fabtech lift kit, into the holes. They fit real snug and then i glassed right over them. The were made of hard plastic so i was able to sand them flush with the transom. Call me crazy but it looked funny and worked really well.
just check the ups tracking that diverter will be in your door today
ya i did. thanks. I'm assuming that you got my check then?
yes im good to go is all fine with you ?
cyclone, Got any pics of the Rogers project?
Nitro. Ya the parts look perfect. thanks again.
Antrant- I'll have pictures next week. Got to get them scanned. I just sent the tunnel ram and some other stuff to the chrome shop and should have pictures of the motor all assembled next week too.